I had so much fun with my Lattice Fold Ornament, I just had to make one into a wreath! There are a few more directions below to change the Lattice Fold Ornament into the wreath, but check out the other post for the full directions.
You are going to fold the Lattice Die cut just like you did for the other ornament, then you are going to cut out the middle. I have shown below where you cut with the red lines. Do this after you have folded and glued the loops together to make it easier to assemble.
Once they are cut, you can put them together. The wreath only uses three lattice shapes so it pops up a little bit when they are all together. (The other one used four.)
Once they are together, fold back the outside ovals so the center bumps up, but the wreath lays flat. make a second one and glue it to the back to make them stronger and to be more 3-D.